Controls And Indicators; Led And Beeper Indications - Datalogic Magellan 9500 Product Reference Manual

Controls and Indicators

NOTE

LED and Beeper Indications

Scanner (Green) LED
Scale (Yellow) LED
Table A-1. Scanner and Scale LED Indications
LED
INDICATION
Scale (Yellow) LED on steady
a
Scale at Zero
a
Scanner (Green) LED on steady and
Scanner Active
dim
(Normal Mode)
Good Read
Scanner (Green) LED - bright flash
a
Indication
Scanner (Green) LED - Continuous
Program Mode
flashing
Indication
Sleep Mode Scanner (Green) LED flashes slowly
Indication
A-2
The control panel consists of three indicator LEDs and three push buttons
as described in the following pages. The unit also includes a beeper which
can be configured to sound indications of scanning, weighing, and deacti-
vation activities.
Since beeper indications are configurable, your unit may not be pro-
grammed to sound all the indications listed. For more information, see
the Programming chapter of this manual.
Scanner and Scale LEDs
The Scanner LED (green, top-most) indicates scanner status, and the
Scale LED (yellow, middle) is primarily used to show scale status (see
).
Table A-1
DURATION COMMENT
The scale is at rest and reads zero weight. The
scale is ready to weigh.
The scanner is ready for operation. Scanning is
immediately available.
Indicates a bar code has been read and decoded.
Indicates the scanner is in Label Programming
Mode. Cycle power to exit Programming Mode.
The scanner motor and/or laser have automati-
cally switched off and the unit has entered Sleep
Mode due to extended inactivity.
®
Magellan 9500