Volume/Tone Push Button - Datalogic Magellan 9500 Product Reference Manual

Table A-2. EAS Indications
Deactivation (Tri-color) LED
flashes Red, then Orange,
Deactivation
then returns to Green.
Indicated
a. Additionally, the FRU LED (7-segment display located in the bottom of the optic cavity — visi-
ble through the horizontal scan window) blinks the number '9'. If EAS deactivation fails to ini-
tiate, a low, error tone will be sounded, and the FRU LED will display the error code '9' steadily
(without flashing).
b. Ticking sound will stop upon one of the following: 1) Manual EAS Deactivation Push Button is
pressed and released again, 2) EAS timer runs out, or 3) Following a successful EAS tag
deactivation.

Volume/Tone Push Button

NOTE
Table A-3. Volume/Tone Push Button Functions
PRESS
DURATION
Momentary (when
scanner is asleep)
Momentary (when
scanner is awake)
A-6
HYBRID MODE
The Volume/Tone Push Button also performs multiple functions depend-
ing upon the duration of time it is pressed:
Volume changes made using the Volume/Tone Push Button are lost
when the scanner is powered-down and are reset to the factory default
setting. If you wish to permanently change the volume, use the special
programming labels in
FUNCTION
Wakes scanner from Sleep
Mode
Increments volume
High frequency beep
6, Programming.
Chapter
COMMENT
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- A weight change on the scale.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase speaker
volume. When the loudest volume is reached, a
repeated press of the push button cycles volume back
to the lowest setting, then volume increases on subse-
quent press(es). Five volume levels are available.
An EAS tag has
been successfully
deactivated.
®
Magellan 9500