System Power-Up Recap - Datalogic Magellan 9500 Product Reference Manual

System Power-Up Recap

NOTE
Product Reference Guide
The System Power-Up procedure may vary depending upon the require-
ments of your POS system. It is generally a good practice to power-down
(switch off ) all equipment prior to connecting cables. Check with your
System Supervisor and/or refer to your POS terminal manual for proper
power-down and power-up procedures and interface requirements when
connecting any peripheral device.
If you have not identified any specific requirements for your POS system,
follow these steps.
1. Power-down the POS terminal.
2. Ensure that power is disconnected from the scanner.
3. Connect the scanner and scale interface cables to your POS termi-
nal. This connection may use one or two cables depending upon
your POS terminal interface.
4. Connect the EAS interface cable.
Always Apply power to the EAS Controller box before powering on the scan-
ner.
5. Connect the Remote Display cable if your model is a scanner/scale
and make any connections to optional equipment, such as a hand-
held scanner.
System Power-Up Recap
2-41