Codabar Length Control; Codabar Set Length 1 - Datalogic Gryphon 2D Series Reference Manual

CODABAR

Codabar Length Control

This feature specifies either variable length decoding or fixed length decoding for the
Codabar symbology.
Variable Length:
Fixed Length:
$CCBLC00
Codabar Length Control = Fixed Length

Codabar Set Length 1

This feature specifies one of the bar code lengths for "
. Length 1 is the minimum label length if in Variable Length Mode, or the first fixed
181
length if in Fixed Length Mode. Length includes the bar code's start, stop, check and
data characters. The length must include at least one data character.
The length can be set from 3 to 50 characters. See "
detailed programming instructions.
Select Codabar Length 1 Setting
$CCBL1
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
For variable-length decoding, a minimum length may be set.
For fixed-length decoding, two different lengths may be set.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.

Length 1 = 03 (3 characters)
ENTER/EXIT PROGRAMMING MODE

Codabar Length Control = Variable Length
$CCBLC01
Codabar Length Control" on page
Set Length 1" on page 293
Appendix D, Keypad
CANCEL
PRODUCT REFERENCE GUIDE
for more
represent-
181