Standard 2 Of 5 Minimum Label Length - Datalogic Magellan 9500 Product Reference Manual

Standard 2 of 5 Minimum Label Length

NOTE
6-276
This feature specifies the minimum allowable length of an Standard 2 of 5
label.
Length in this case includes check and data characters, but does not
include start or stop characters. This feature applies when Standard 2
of 5 Length Control is set to variable-length decoding.
Minimum label length should be less than or equal to maximum label
length.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code,
below. You'll need to cover any unused bar codes on this
LENGTH
and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate digits from the keypad in
represent the desired minimum label length. The selectable range
for this option is 01 to 50, even numbers only. Pad all single digit
numbers with a leading zero to yield a two-digit entry (01-50).
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET STANDARD 2 OF 5 MINIMUM LABEL LENGTH
SET STANDARD 2 OF 5 MINIMUM LABEL
that
Appendix C
®
Magellan 9500