Maximum Host-Transmitted Message Length - Datalogic Magellan 9500 Product Reference Manual

Maximum Host-Transmitted Message Length

NOTE
6-66
Specifies the maximum number of data characters allowed in messages
transmitted to the host.
To set the Maximum Host-Transmitted Message Length:
1. Scan the SWITCH bar code.
2. Scan the bar code,
SAGE LENGTH
on this and the facing page to ensure that the scanner reads only the
bar code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C that rep-
resent the desired maximum host-transmitted message length. The
selectable range is 0-249 data characters. (Labels that are longer than
this length are not read.) Pad all single and double digit numbers
with leading zeroes to yield a three-digit entry (000-249).
If this configuration item is set to 0 (000), there is no general length limit
imposed on data being transmitted to the host.
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned
SET MAXIMUM HOST-TRANSMITTED MESSAGE LENGTH
SET MAXIMUM HOST-TRANSMITTED MES-
below. You'll need to cover any unused bar codes
®
Magellan 9500