Creating Avc Qos Policy - Cisco Catalyst 9500 Manual

Creating AVC QoS Policy

Command or Action
Step 2 interface interface-id
Example:
Device(config)# interface gigabitethernet 1/0/1
Step 3
ip nbar protocol-discovery
Example:
Device(config-if)# ip nbar protocol-discovery
Step 4 end
Example:
Device(config-if)# end
Creating AVC QoS Policy
To create AVC QoS policy, perform these general steps:
1. Create a class map with match protocol filters.
2. Create a policy map.
3. Apply the policy map to the interface.
Creating a Class Map
You need to create a class map before configuring any match protocol filter. The QoS actions such as marking
and policing can be applied to the traffic. The AVC match protocol filters are applied to the wired access
ports. For more information about the protocols that are supported, see
ios-xml/ios/qos_nbar/prot_lib/config_library/nbar-prot-pack-library.html.
SUMMARY STEPS
1. terminal
2. class-map class-map-name
3. match protocol application-name
4. end
DETAILED STEPS
Command or Action
Step 1
terminal
Example:
Device# configure terminal
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
112
Configuring Application Visibility and Control in a Wired Network
Purpose
Specifies the interface for which you are enabling
protocol-discovery and enters interface configuration mode.
Enables application recognition on the interface by
activating NBAR2 engine.
Returns to privileged EXEC mode.
http://www.cisco.com/c/en/us/td/docs/
Purpose
Enters global configuration mode.