Configuring Default Zone Qos Priority Attributes - Cisco MDS 9000 Series Configuration Manual

Configuring and Managing Zones
Figure 38: Zone Policies Tab in the Information Pane
Step 3
Use the check boxes and drop-down menus to configure QoS on the default zone.
Step 4 Click Apply Changes to save the changes.

Configuring Default Zone QoS Priority Attributes

QoS priority attribute configuration changes take effect when you activate the zoneset of the associated zone.
Note If a member is part of two zones with two different QoS priority attributes, the higher QoS value is implemented.
This situation does not arise in the VSAN-based QoS as the first matching entry is implemented.
To configure the QoS priority attributes for a default zone, follow these steps:
Step 1
switch# configure terminal
Example:
switch(config)#
Enters configuration mode.
Step 2
switch(config)# zone default-zone vsan 1
Example:
switch(config-default-zone)#
Enters the default zone configuration submode.
Step 3
switch(config-default-zone)# attribute qos priority high
Sets the QoS priority attribute for frames matching these zones.
Step 4 switch(config-default-zone)# no attribute qos priority high
Configuring Default Zone QoS Priority Attributes
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
91