Reverting To The Default Policy For A Specific Counter - Cisco MDS 9000 Series Configuration Manual

Configuring Interfaces
switch(config)# port-group-monitor name policyname
(Optional) Remove the policy:
switch(config)# no port-group-monitor name policyname
Step 3 Specify the delta receive or transmit counter poll interval (in seconds) and thresholds (in percentage):
switch(config-port-group-monitor)# counter {rx-datarate | tx-datarate} poll-interval seconds delta rising-threshold
percentage1 falling-threshold percentage2
(Optional) Revert to the default policy:
switch(config-port-group-monitor)# no counter tx-datarate
For more information on reverting to the default policy, see
Port Group Monitor.
Step 4
Turn on datarate monitoring:
switch(config-port-group-monitor)# monitor counter {rx-datarate | tx-datarate}
(Optional) Turn off datarate monitoring:
switch(config-port-group-monitor)# no monitor counter {rx-datarate | tx-datarate}
For more information on turning off transmit datarate monitoring, see
On 8-Gbps and higher speed modules, port errors are monitored using the invalid-crc and invalid-words
Note
counters. The err-pkt-from-port counter is supported only on 4-Gbps modules.

Reverting to the Default Policy for a Specific Counter

The following examples display the default values for counters:
switch(config)# port-group-monitor name PGMON_policy
switch(config-port-group-monitor)# counter tx-datarate poll-interval 200 delta
rising-threshold 75 falling-threshold 0
switch(config)# show port-group-monitor PGMON_policy
Policy Name
Admin status : Not Active
Oper status
Port type
------------------------------------------------------------------------------------------
Counter
-------
RX Datarate
TX Datarate
switch(config-port-group-monitor)# no counter tx-datarate
switch(config)# show port-group-monitor PGMON_policy
Policy Name
Admin status : Not Active
Oper status
Port type
------------------------------------------------------------------------------------------
Counter
-------
RX Datarate
: PGMON_policy
: Not Active
: All Port Groups
Threshold Interval %ge Rising Threshold %ge Falling Threshold
--------- -------- -------------------- ---------------------
Delta 200 75
Delta 60 80
: PGMON_policy
: Not Active
: All Port Groups
Threshold Interval %ge Rising Threshold %ge Falling Threshold
--------- -------- -------------------- ----------------------
Delta 60 80
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
Reverting to the Default Policy for a Specific Counter
Reverting to the Default Policy for a Specific Counter
Turning Off Specific Counter
0
20
10
and
Monitoring.
57