Alarm Profile (Global Configuration) - Cisco IE-3000-8TC Command Reference Manual

alarm profile (global configuration)

alarm profile (global configuration)
Use the alarm profile global configuration command to create an alarm profile and to enter alarm profile
configuration mode. Use the no form of this command to delete an alarm profile.
Syntax Description
name
Defaults No alarm profiles are created. However, there is a default profile for all interfaces called defaultPort.
When a profile is created, none of the alarms are enabled.
Command Modes Global configuration
Command History Release
12.2(44)EX
Usage Guidelines In alarm-profile configuration mode, these commands are available:
•
•
•
•
•
•
•
•
For alarm-id, you can enter one or more alarm IDs separated by a space.
Before you use the notifies keyword to send alarm traps to a SNMP host, you need to set up an SNMP
server by using the snmp-server enable traps global configuration command.
There is a default profile for all interfaces. Enter the show alarm profile user EXEC command and see
the output for defaultPort.
Table 2-1
Cisco IE 3000 Switch Command Reference
2-10
alarm profile name
no alarm profile name
Alarm profile name
Modification
This command was introduced.
alarm alarm-id: enables the specified alarm.
exit: exits from alarm-profile configuration mode.
help: displays a description of the interactive help system.
no: negates or sets the default values of a command.
notifies alarm-id: enables notification for the alarm, which means sending a Simple Network
Management Protocol (SNMP) trap to an SNMP server.
relay-major alarm-id: enables sending the alarm to the major relay circuitry.
relay-minor alarm-id: enables sending the alarm to the minor relay circuitry.
syslog alarm-id: enables sending the alarm to a syslog file.
lists the alarm IDs and the corresponding alarm descriptions.
Chapter 2 IE 3000 Switch Cisco IOS Commands
OL-13019-01