Defining Ipv6 Global Configuration; Defining An Ipv6 Interface - Cisco SF 300-08 Administration Manual

Configuring IP Information
Management and IP Interfaces
STEP 1
STEP 2
STEP 3
STEP 1
Cisco Small Business 300 Series Managed Switch Administration Guide

Defining IPv6 Global Configuration

The IPv6 Global Configuration Page defines the frequency of the IPv6 ICMP error
messages generated by the switch.
To define IPv6 global parameters:
In Layer 2 mode, click Administration > Management Interface > IPv6 Global
Configuration.
In Layer 3 mode, click IP Configuration > Management and IP Interface > IPv6
Global Configuration.
The IPv6 Global Configuration Page opens.
Enter the values for the following fields:
• ICMPv6 Rate Limit Interval—Enter the time limit.
• ICMPv6 Rate Limit Bucket Size—Enter the maximum number of ICMP error
message that can be sent by the switch per interval.
Click Apply. The IPv6 address settings are defined, and the switch is updated.

Defining an IPv6 Interface

The IPv6 Interfaces Page displays the switch's IPv6 interface parameters and
enables configuring this interface. An IPv6 interface can be configured on a port, a
LAG, VLAN, or ISATAP tunnel interface. The switch supports one IPv6 interface as
an IPv6 end device.
A tunnel interface is configured with an IPv6 address based on the settings
defined in the IPv6 Tunnel Page.
To configure IPv6 interfaces:
In Layer 2 mode, click Administration > Management Interface > IPv6
Interfaces.
15
173