Cisco IE-3000-8TC Command Reference Manual page 22

CLI Command Modes
Table 1-1
and how to exit that mode. The prompts listed use the default name Switch.
Table 1-1 Command Modes Summary
Command Mode Access Method
User EXEC This is the first level of access.
(For the switch) Change terminal
settings, perform basic tasks, and
list system information.
Privileged EXEC From user EXEC mode, enter the
enable command.
Global From privileged EXEC mode,
configuration enter the configure command.
Interface From global configuration mode,
configuration specify an interface by entering
the interface command followed
by an interface identification.
Config-vlan In global configuration mode,
enter the vlan vlan-id command.
VLAN From privileged EXEC mode,
configuration enter the vlan database
command.
Line configuration From global configuration mode,
specify a line by entering the line
command.
Cisco IE 3000 Switch Command Reference
1-2
lists the main command modes, how to access each mode, the prompt you see in that mode,
Prompt
Switch>
Switch#
Switch(config)#
Switch(config-if)#
Switch(config-vlan)#
Switch(vlan)#
Switch(config-line)#
Chapter 1 Using the Command-Line Interface
Exit or Access Next Mode
Enter the logout command.
To enter privileged EXEC mode, enter
the enable command.
To exit to user EXEC mode, enter the
disable command.
To enter global configuration mode,
enter the configure command.
To exit to privileged EXEC mode,
enter the exit or end command, or
press Ctrl-Z.
To enter interface configuration mode,
enter the interface configuration
command.
To exit to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
To exit to global configuration mode,
enter the exit command.
To exit to global configuration mode,
enter the exit command.
To return to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
To exit to privileged EXEC mode,
enter the exit command.
To exit to global configuration mode,
enter the exit command.
To return to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
OL-13019-01