Advertisement
Quick Links
Switch Mounting
•
Switch Mounting
This chapter describes how to mount the switch.
Mounting the Switch
Caution
To prevent the switch from overheating, ensure these minimum clearances:– Top and bottom: 2.0 in. (50.8
mm)– Exposed side (not connected to the module): 2.0 in. (50.8 mm) – Front: 2.0 in. (50.8 mm)
Installing the Switch on the Wall
To attach the switch to a wall or a panel, follow these steps.
Warning
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware
or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
Statement 378
Procedure
Step 1
Position the switch mounting bracket against the wall or a panel in the desired location, with the arrow pointing
up. See the following figure. Attach the bracket to the wall with the 4 enclosed Philips screws.
Switch Mounting, on page 1
Switch Mounting
1
Advertisement
Related Manuals for Cisco IE3400H
Summary of Contents for Cisco IE3400H
- Page 1 Switch Mounting • Switch Mounting, on page 1 Switch Mounting This chapter describes how to mount the switch. Mounting the Switch Caution To prevent the switch from overheating, ensure these minimum clearances:– Top and bottom: 2.0 in. (50.8 mm)– Exposed side (not connected to the module): 2.0 in. (50.8 mm) – Front: 2.0 in. (50.8 mm) Installing the Switch on the Wall To attach the switch to a wall or a panel, follow these steps.
- Page 2 Switch Mounting Installing the Switch on the Wall Figure 1: Mounting Wall Bracket to Wall When attaching the bracket to the wall or pannel, ensure that the screws engage a stud or support Note structure capable of supporting the weight of the bracket and the switch. Step 2 Loosly attach the 4 mounting screws to the switch and slide it into the bracket and down.
- Page 3 Switch Mounting Installing the Switch on the Wall Figure 2: Attaching the Switch to the Mounting Bracket Step 3 To remove the switch, loosen the 4 mounting screws and slide the switch up and forward, out of the mounting bracket. Then the bracket itself can be unscrewed from the wall, if necessary. What to do next After the switch is mounted on the wall or panel, connect the power and alarm wires, as described in the “Connecting Alarm Circuits”...
- Page 4 Switch Mounting Installing the Switch on the Wall Switch Mounting...