Cisco IE-3000-8TC Command Reference Manual page 395

Chapter 2 IE 3000 Switch Cisco IOS Commands
trunk
| begin
| exclude
| include
expression
1. Coarse wavelength-division multiplexer
2. Dense wavelength-division multiplexer
Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
Note
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History Release
12.2(44)EX
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
•
•
•
•
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples
This is an example of output from the show interfaces command for an interface:
Switch# show interfaces gigabitethernet1/2
GigabitEthernet1/2 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 001e.1300.4882 (bia 001e.1300.4882)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output 00:00:00, output hang never
Last clearing of ''show interface'' counters never
OL-13019-01
Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Use the show interfaces capabilities module 1 to display the capabilities of all interfaces on the
switch. Entering any other number is invalid.
Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
Use the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces on the switch.
Use the show interfaces switchport module 1 to display the switch port characteristics of all
interfaces on the switch. Entering any other number is invalid.
reliability 255/255, txload 1/255, rxload 1/255
Cisco IE 3000 Switch Command Reference
show interfaces
2-369