Spanning-Tree Mst Root - Cisco IE-3000-8TC Command Reference Manual

spanning-tree mst root

spanning-tree mst root
Use the spanning-tree mst root global configuration command to configure the multiple spanning-tree
(MST) root switch priority and timers based on the network diameter. Use the no form of this command
to return to the default settings.
Syntax Description instance-id
root primary
root secondary
diameter net-diameter
hello-time seconds
Defaults The primary root switch priority is 24576.
The secondary root switch priority is 28672.
The hello time is 2 seconds.
Command Modes
Global configuration
Command History Release
12.2(44)EX
Usage Guidelines
Use the spanning-tree mst instance-id root command only on backbone switches.
When you enter the spanning-tree mst instance-id root command, the software tries to set a high
enough priority to make this switch the root of the spanning-tree instance. Because of the extended
system ID support, the switch sets the switch priority for the instance to 24576 if this value will cause
this switch to become the root for the specified instance. If any root switch for the specified instance has
a switch priority lower than 24576, the switch sets its own priority to 4096 less than the lowest switch
priority. (4096 is the value of the least-significant bit of a 4-bit switch priority value.)
Cisco IE 3000 Switch Command Reference
2-532
spanning-tree mst instance-id root {primary | secondary} [diameter net-diameter
[hello-time seconds]]
no spanning-tree mst instance-id root
Range of spanning-tree instances. You can specify a single instance, a range
of instances separated by a hyphen, or a series of instances separated by a
comma. The range is 0 to 4094.
Force this switch to be the root switch.
Set this switch to be the root switch should the primary root switch fail.
(Optional) Set the maximum number of switches between any two end
stations. The range is 2 to 7. This keyword is available only for MST
instance 0.
(Optional) Set the interval between hello bridge protocol data units
(BPDUs) sent by the root switch configuration messages. The range is 1 to 10
seconds. This keyword is available only for MST instance 0.
Modification
This command was introduced.
Chapter 2 IE 3000 Switch Cisco IOS Commands
OL-13019-01