Mdix Auto - Cisco IE-3000-8TC Command Reference Manual

Chapter 2 IE 3000 Switch Cisco IOS Commands

mdix auto

Use the mdix auto interface configuration command to enable the automatic medium-dependent
interface crossover (auto-MDIX) feature on the interface. When auto-MDIX is enabled, the interface
automatically detects the required cable connection type (straight-through or crossover) and configures
the connection appropriately. Use the no form of this command to disable auto-MDIX.
Syntax Description This command has no arguments or keywords.
Defaults
Auto-MDIX is enabled.
Command Modes
Interface configuration
Command History Release
12.2(44)EX
Usage Guidelines
When you enable auto-MDIX on an interface, you must also set the interface speed and duplex to auto
so that the feature operates correctly.
When auto-MDIX (and autonegotiation of speed and duplex) is enabled on one or both of connected
interfaces, link up occurs, even if the cable type (straight-through or crossover) is incorrect.
Auto-MDIX is supported on all 10/100 and 10/100/1000 Mb/s interfaces. It is not supported on
1000BASE-SX or -LX small form-factor pluggable (SFP) module interfaces.
Examples This example shows how to enable auto-MDIX on a port:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# speed auto
Switch(config-if)# duplex auto
Switch(config-if)# mdix auto
Switch(config-if)# end
You can verify the operational state of auto-MDIX on the interface by entering the show controllers
ethernet-controller interface-id phy privileged EXEC command.
OL-13019-01
mdix auto
no mdix auto
Modification
This command was introduced.
Cisco IE 3000 Switch Command Reference
mdix auto
2-209