Chapter 2
IE 3000 Switch Cisco IOS Commands
mls qos srr-queue input dscp-map
Use the mls qos srr-queue input dscp-map global configuration command to map Differentiated
Services Code Point (DSCP) values to an ingress queue or to map DSCP values to a queue and to a
threshold ID. Use the no form of this command to return to the default setting.
Syntax Description
queue queue-id
dscp1...dscp8
threshold threshold-id
dscp1...dscp8
Defaults
Table 2-12
Table 2-12
DSCP Value
0–39
40–47
48–63
Command Modes
Global configuration
Command History
Release
12.2(44)EX
Usage Guidelines
The DSCP assigned at the ingress port selects an ingress or egress queue and threshold.
The drop-threshold percentage for threshold 3 is predefined. It is set to the queue-full state. You can
assign two weighted tail-drop (WTD) threshold percentages to an ingress queue by using the mls qos
srr-queue input threshold global configuration command.
OL-13019-01
mls qos srr-queue input dscp-map queue queue-id {dscp1...dscp8 | threshold threshold-id
dscp1...dscp8}
no mls qos srr-queue input dscp-map
Specify a queue number.
For queue-id, the range is 1 to 2.
Map DSCP values to an ingress queue.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
Map DSCP values to a queue threshold ID.
For threshold-id, the range is 1 to 3.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
shows the default DSCP input queue threshold map:
Default DSCP Input Queue Threshold Map
Queue ID–Threshold ID
1–1
2–1
1–1
Modification
This command was introduced.
mls qos srr-queue input dscp-map
Cisco IE 3000 Switch Command Reference
2-237