Debug Etherchannel - Cisco IE-3000-8TC Command Reference Manual

Appendix B IE 3000 Switch Debug Commands

debug etherchannel

Use the debug etherchannel privileged EXEC command to enable debugging of the
EtherChannel/PAgP shim. This shim is the software module that is the interface between the Port
Aggregation Protocol (PAgP) software module and the port manager software module. Use the no form
of this command to disable debugging.
Syntax Description all
detail
error
event
idb
Note Though visible in the command-line help strings, the linecard keyword is not supported.
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(44)EX
Usage Guidelines If you do not specify a keyword, all debug messages appear.
The undebug etherchannel command is the same as the no debug etherchannel command.
Related Commands Command
show debugging
show etherchannel
OL-13019-01
debug etherchannel [all | detail | error | event | idb]
no debug etherchannel [all | detail | error | event | idb]
(Optional) Display all EtherChannel debug messages.
(Optional) Display detailed EtherChannel debug messages.
(Optional) Display EtherChannel error debug messages.
(Optional) Debug major EtherChannel event messages.
(Optional) Display PAgP interface descriptor block debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays EtherChannel information for the channel.
Cisco IE 3000 Switch Command Reference
debug etherchannel
B-11