Cisco IE-3000-8TC Command Reference Manual page 328

setup express
You can verify that Express Setup mode is enabled by pressing the Express Setup button:
•
•
If you hold the Express Setup button down for a total of 10 seconds, the configuration is deleted, and the
Caution
switch reboots.
This example shows how to disable Express Setup mode:
Switch(config)# no setup express
You can verify that Express Setup mode is disabled by pressing the Express Setup button. The LEDs do
not turn solid green or begin blinking green if Express Setup mode is not enabled on the switch.
Related Commands Command
show setup express
Cisco IE 3000 Switch Command Reference
2-302
On an unconfigured switch, the LEDs below the Express Setup button turn solid green after 3
seconds.
On a configured switch, the mode LEDs begin blinking after 2 seconds and turn solid green after 10
seconds.
Description
Displays if Express Setup mode is active.
Chapter 2 IE 3000 Switch Cisco IOS Commands
OL-13019-01