Show Pagp - Cisco IE-3000-8TC Command Reference Manual

Chapter 2 IE 3000 Switch Cisco IOS Commands

show pagp

Use the show pagp user EXEC command to display Port Aggregation Protocol (PAgP) channel-group
information.
Syntax Description channel-group-number
counters
internal
neighbor
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History Release
12.2(44)EX
Usage Guidelines
You can enter any show pagp command to display the active channel-group information. To display the
nonactive information, enter the show pagp command with a channel-group number.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output are appear.
Examples
This is an example of output from the show pagp 1 counters command:
Switch> show pagp 1 counters
Port
--------------------------------------
Channel group: 1
Gi1/1
Gi1/2
This is an example of output from the show pagp 1 internal command:
Switch> show pagp 1 internal
Flags:
Timers: H - Hello timer is running.
Channel group 1
OL-13019-01
show pagp [channel-group-number] {counters | internal | neighbor} [ | {begin | exclude |
include} expression]]
(Optional) Number of the channel group. The range is 1 to 6.
Display traffic information.
Display internal information.
Display neighbor information.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Information
Sent Recv
45 42
45 41
S - Device is sending Slow hello.
A - Device is in Auto mode.
S - Switching timer is running.
Flush
Sent Recv
0 0
0 0
C - Device is in Consistent state.
Q - Quit timer is running.
I - Interface timer is running.
Cisco IE 3000 Switch Command Reference
show pagp
2-451