Alarm Profile (Interface Configuration) - Cisco IE-3000-8TC Command Reference Manual

alarm profile (interface configuration)

alarm profile (interface configuration)
Use the alarm profile interface configuration command to attach an alarm profile to a port. Use the no
form of this command to detach the profile from the port.
Syntax Description
name
Defaults The alarm profile defaultPort is applied to all interfaces. In this profile, only the Port Not Operating
alarm is enabled.
Command Modes Interface configuration
Command History Release
12.2(44)EX
Usage Guidelines Use the alarm profile global configuration command to create the alarm profile, enabling one or more
alarms and specifying the alarm options.
You can attach only one alarm profile to an interface.
When you attach an alarm profile to an interface, it overwrites any previous alarm profile that was
attached to the interface (including the defaultPort profile).
Examples This example shows how to attach an alarm profile named fastE to a port:
Switch(config)# interface fastethernet1/2
Switch(config-if)# alarm profile fastE
This example shows how to detach the alarm profile from a port and return it to the defaultPort profile:
Switch(config)# interface fastethernet1/2
Switch(config-if)# no alarm profile
Related Commands Command
alarm profile (global
configuration)
show alarm profile
Cisco IE 3000 Switch Command Reference
2-12
alarm profile name
no alarm profile
Alarm profile name
Modification
This command was introduced.
Description
Creates or identifies an alarm profile and enters alarm-profile configuration
mode.
Displays all alarm profiles or a specified alarm profile and lists the interfaces
to which each profile is attached.
Chapter 2 IE 3000 Switch Cisco IOS Commands
OL-13019-01