Location (Interface Configuration) - Cisco IE-3000-8TC Command Reference Manual

Chapter 2 IE 3000 Switch Cisco IOS Commands

location (interface configuration)

Use the location interface command to enter location information for an interface. Use the no form of
this command to remove the interface location information.
Syntax Description
additional-location-information
civic-location-id
elin-location-id
id
word
Defaults This command has no default setting.
Command Modes
Interface configuration
Command History Release
12.2(44)EX
Usage Guidelines
After entering the location civic-location-id id interface configuration command, you enter civic
location configuration mode. In this mode, you can enter the additional location information.
Examples
These examples show how to enter civic location information for an interface:
Switch(config-if)# int g1/1
Switch(config-if)# location civic-location-id 1
Switch(config-if)# end
Switch(config-if)# int g1/1
Switch(config-if)# location civic-location-id 1
Switch(config-if)# end
You can verify your settings by entering the show location civic interface privileged EXEC command.
This example shows how to enter emergency location information for an interface:
Switch(config)# int g1/2
Switch(config-if)# location elin-location-id 1
Switch(config-if)# end
OL-13019-01
location {additional-location-information word | civic-location-id id | elin-location-id id}
no location {additional-location-information word | civic-location-id id | elin-location-id id}
Modification
This command was introduced.
Configure additional information for a location or place.
Configure global civic location information for an interface.
Configure emergency location information for an interface.
Specify the ID for the civic location or the elin location. The ID
range is 1 to 4095.
Specify a word or phrase that provides additional location
information.
Cisco IE 3000 Switch Command Reference
location (interface configuration)
2-177