Triton T1/Pri Trunk Properties - Altigen AltiWare OE Version 4.6 Administration Manual

Parameter
G723 Jitter Buffer
Range (ms)
G711 RTP Packet
Length (ms)
Type
Debugging the Triton VoIP Configuration
Click the Debug button in the Triton VoIP Configuration dialog box (see
Figure 6) to open a small dialog box for typing and sending a debug string.

Triton T1/PRI Trunk Properties

To configure a Triton T1/PRI channel, select a Triton T1/PRI channel from
the trunk channels list in the Trunk Configuration window, then click the
Trunk Properties button or double-click the list entry to view the Triton
T1/PRI Trunk Line Properties dialog box.
AltiWare OE System Installation & Administration Manual
Description
Indicates the delay, in milliseconds, used to buffer
G.723 voice packets received from the IP network.
Voice packets sent over the IP network may incur
different delays due to network load or congestion.
The jitter buffer helps to smooth out the delay
variation in the arriving voice packets and maintain
voice quality at the receiving end. The initial value
for the jitter buffer is 10 min. to 20 max milliseconds.
The jitter buffer should be adjusted according to the
WAN bandwidth allocated to data traffic.
Lets you configure the length of the RTP packets for
G.711 in milliseconds. The RTP packet length can be
set to 10, 20 or 30 milliseconds.
Note: A maximum range of 30 ms is not supported
for the Cisco router.
Lets you select between a 12-port G.723.1
configuration and a 30-port G.711 configuration.
This is available only with the 12-port board and 30-
port upgrade license.
Trunk Configuration
7-15