Limitation Of Liability - Altigen AltiWare OE Version 4.6 Administration Manual

Liability & Warranty

Limitation of Liability

Except for personal injury, direct damages to tangible personal property proximately caused
by AltiGen products and liability otherwise expressly assumed in a written agreement signed
by AltiGen, the liability of AltiGen, its affiliates, suppliers, and authorized resellers for any
claims, losses, damages, or expenses from any cause whatsoever (including acts of omission
of third parties), regardless of the form of action, whether in contract, tort or otherwise, shall
not exceed an amount equal to the lesser of the direct damages proven or the purchase price
of the product. In no event shall AltiGen or its affiliates, suppliers, or authorized resellers be
liable for incidental, consequential, or any other indirect loss or damage (including lost profits
or revenues) incurred in connection with the product. This limitation of liability shall survive
failure of the exclusive remedy set forth in the limited warranty referred to in this book under
"Warranty."
FCC and Industry Canada Compliance
This section describes the requirements for compliance with Federal Communications (FCC)
Rules and Industry Canada CS-03 standard.
Statement
This equipment has been tested and found to be in compliance with the limits for a Class B
digital device pursuant to Part 15 and Part 68 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in
a commercial or residential environment. This equipment generates and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
This Class B digital apparatus meets all requirements of the Canadian interference-causing
Equipment Regulations. Cet apparell numérique de la Classe B respecte toutes les exigences
du Reglement sur le materiel brouilleur du Canada.
FCC Requirements
1. The Federal Communications Commission (FCC) has established Rules which permit
this device to be directly connected to the telephone network. Standardized jacks are used
for these connections. This equipment should not be used on party lines or coin phones.
2. If this device is malfunctioning, it may also be causing harm to the telephone network;
this device should be disconnected until the source of the problem can be determined and
until repair has been made. If this is not done, the telephone company may temporarily
disconnect service.
3. The telephone company may make changes in its technical operations and procedures; if
such changes affect the compatibility or use of this device, the telephone company is
required to give adequate notice of the changes. You will be advised of your rights to file
a complaint with the FCC.
4. If the telephone company requests information on what equipment is connected to their
lines, inform them of:
AltiWare OE System Installation & Administration Manual xv