Table of Contents
Advertisement
Parameter
Pause Detect Length
Setting E-mail Messaging (SMTP/POP3) Options
To use the AltiWare email services, configure the following settings.
Parameter
Enable SMTP/POP3
E-Mail Service
Allow Inbound
Internet Mail
Postmaster Ext
AltiWare OE System Installation & Administration Manual
Description
Selected, this feature causes the deletion of pauses in
messages. The default pause detect length is 500 ms.
The pause detect can be disabled by deselecting the
check box, or the length can be set to a value between
200–2000 ms (.2–2 seconds).
Description
Selected, this enables incoming and outgoing mail
services on AltiServ—Simple Mail Transfer
Protocol (SMTP) and Post Office Protocol (POP).
This check box option is activated and selected by
default if you enable the SMTP/POP E-Mail Service.
You can deselect this option if you don't want to use
the AltiWare E-Mail service for inbound mail; for
example when you're using another email server on
the AltiServ system.
This field defines the extension that will be assigned
as a Postmaster Extension. When the e-mail system
receives an e-mail with an invalid e-mail account, the
automatic reply (informing of the invalid e-mail
account used) to the sender is sent from the defined
extension.
Note: The system always requires an extension to
selected as the Postmaster Extension. By
default, the first extension in the system is
used. If an extension is selected as the
Postmaster Extension, it cannot be deleted
until the Postmaster Extension is re-assigned
to another extension.
System Configuration
5-25
Advertisement
Table of Contents
Troubleshooting
