Enabling Hop Off For Tie Trunks; Creating Account Codes - Altigen AltiWare OE Version 4.6 Administration Manual

Enabling Hop Off for Tie Trunks

When selected, this function allows calls over T1 tie trunks to use PSTN
trunks or other servers, when those trunks have been configured to accept
tie-trunk calls. For Hop Off to work, it must be enabled on all AltiServ
systems on which trunk calls are able to be used as a transit switch.
Outgoing
call on
PSTN Trunk
The call originating on System B hops off over the T1/PRI or VoIP trunk to use the PSTN
trunk in System A. Both System A and System B must be set up and configured to use
hop-off for tie-trunks.
Figure 7. Hop Off for Tie Trunks
The trunk configuration to allow this function is discussed under "Setting
General Trunk Attributes" on page 7-3.
The board must be configured to allow for tie trunks, as discussed in
"Setting up T1 or PRI Channels on the Triton T1/PRI Board" on page 6-39.
Restricting Tie Trunk Calls
You can set call restrictions on tie trunk calls by telling the system to use
the same restrictions as the ones set up for an extension. Using the Call
restriction follows extension drop-down list, you can select the extension
with the restrictions to use for the tie trunk calls.

Creating Account Codes

Account Codes let you enable or force users to assign incoming and
outgoing calls to particular account codes for billing, tracking, or
forecasting purposes.
AltiWare OE System Installation & Administration Manual
Tie Trunk:
T1/PRI or VoIP
System A
System Configuration
System B
5-15