Altigen AltiWare OE Version 4.6 Administration Manual page 243

Parameter Description
You can select the maximum time-out delays, in seconds and the appropriate
sequence of symbols to be collected for Caller ID and DID.
Max. seconds Maximum wait time before time-out for the system to
before the first identify this digit after either the first ring in ground start or
digit loop start or the wink in wink start. The range is from 1-6
seconds, or None, with a default value of 3 seconds. Do not
change this value unless advised.
'None' means no Caller ID or DID information will be
collected. All other options will be grayed out. Use this
option to disable Caller ID and DID collection.
Max. seconds Maximum wait time before time-out between two digits.
between digits Default value is 'None.' Do not change this value unless
advised.
Selecting 'None' means the system will only wait for the
sequence of digits that are collected within the length of
time specified in the Max. seconds before the first digit
field.
Incoming Select up to five incoming symbols to collect from the
sequence Caller ID or DID digits:
• None
• #
• *
• # or *
• Caller ID
• DID/DNIS
Selecting 'None' in any field of the sequence will terminate
the sequence and automatically disable subsequent entries
in the sequence.
The default sequence is:
"# or *"
then) "
AltiWare OE System Installation & Administration Manual
Caller ID"
(and then) "
DID/DNIS"
Trunk Configuration
# or *"
(and then) " (and
7-17