Configuring the Triton VoIP Board
3.
Configure general trunk parameters on the General tab window of
Trunk Configuration. See "Setting General Trunk Attributes" on
page 7-3.
4.
Configure the dialing plan for connection to remote AltiWare systems
on the IP Dialing Table tab window of System Configuration. Set
the Number of Dialed Digits to "None." Refer to "Defining the IP
Dialing Table" on page 5-29.
5.
Set the VoIP codecs so that servers use the same codec. See "Setting
VoIP Codecs" on page 8-12.
6.
Repeat steps 1 through 5 for all local and remote AltiWare systems that
are to be networked via tie-trunk line connection.
This completes the AltiWare-to-AltiWare network connection. Your
organization is now ready to make and receive IP trunk calls through public
or private IP networks.
Note:
Extension users should refer to the AltiView and AltiServ User
Guide for instructions on how to dial a remote AltiServ. Also, be
sure to distribute the Remote Locations Dialing Chart with your
organization's unique dialing plan. This chart is available in the
AltiView and AltiServ User Guide.
Board Installation
Double click the board's icon in the Boards window (see Figure 1) to open
the Board Configuration window.
6-26 AltiWare OE System Installation & Administration Manual