Parts Identification - Konica Minolta DR1600 Operator's Manual

PARTS IDENTIFICATION

■ PARTS IDENTIFICATION
Power ON/OFF Switch:
1
Shutter Button:
2
Stop Key:
3
Spacing Key:
4
Batch Key:
5
6 Block Key:
7 Total Counter (7-digit):
8 Control Panel:
Resettable Counter (6-digit)
9
[Option] :
Film Unit Release Lever:
10
11 Film Unit Mounting Board:
Film Unit:
12
Copy Board:
13
Lamp Unit:
14
Reduction Ratio Detecting Sensor:
15
Frame Size Detecting Sensor:
16
Foot Pedal Connector [Option] :
17
Foot Pedal [Option] :
18
Used to turn ON and OFF the machine.
Press this Button to make an exposure, advancing film to the next frame.
Press this Key to stop advancing the film or beeps sounding.
Press and release this Key to skip one frame between images without
exposure. Holding it down will advance the film continuously.
Press this Key to allow for generating a large document mark in dual-level
recording or a medium document mark in tri-level recording.
Press this Key to allow for generating a large document mark in tri-level
recording.
Incremented by one each time the Shutter Button is pressed, showing a
running count of frame exposures.
See page 6.
Incremented by one each time the Shutter Button is pressed. It can be
reset to 0.
Place this Lever in the left position before attempting to remove the Film
Unit from the machine, which cuts off power supply to the Film Unit.
Place the Lever in the right position after reinstalling the Film Unit to the
machine.
Serves as a base to hold the Film Unit in position.
Photographs the document and produces a document mark and frame
number on the film.
Serves as the surface on which the documents are placed.
Holds two 15-W fluorescent lamps to illuminate the document on the Copy
Board.
Detects the width of the document to determine the reduction ratio.
Detects the length of the document to determine the frame size.
Connect the Foot Pedals.
4