Dhcp Server Exclude Address Settings; Dhcp Server Pool Settings - D-Link DGS-3612G - xStack Switch Reference Manual

®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch

DHCP Server Exclude Address Settings

The following window will allow the user to set an IP address, or a range of IP addresses that are NOT to be included in the range
of IP addresses that the Switch will allot to clients requesting DHCP service. To set an IP address or range of IP addresses, enter
the Begin Address of the range and then the End Address of the range and click Apply. Set address ranges will appear in the
DHCP Exclude Address Table in the bottom half of the window, as shown below:
To view this window, click L3 features > DHCP Server > DHCP Server Exclude Address Settings, as shown below:
Figure 4- 76. Create DHCP Excluded Address window

DHCP Server Pool Settings

The following windows will allow users to create and then set the parameters for the DHCP Pool of the switch's DHCP server.
Users must first create the pool by entering a name of up to 12 alphanumeric characters into the Pool Name field and clicking
Apply. Once created, users can modify the settings of a pool by clicking its corresponding Modify button.
To view the following window, click L3 features > DHCP Server > DHCP Server Pool Settings, as shown below:
Figure 4- 77. Create DHCP Pool window
To remove an entry from the table, click its corresponding under the Delete heading.
Clicking the Modify button of a corresponding DHCP Pool will lead to the following window in which users can adjust the
settings for the specific DHCP pool table.
234