Dhcp Server Exclude Address Settings; Dhcp Server Pool Settings - D-Link Xstack DES-3528 Series Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide

DHCP Server Exclude Address Settings

The following window will allow the user to set an IP address, or a range of IP addresses that are NOT to be
included in the range of IP addresses that the Switch will allot to clients requesting DHCP service.
To view this window, click Network Application > DHCP > DHCP Server > DHCP Server Exclude Address
Settings, as shown below:
The fields that can be configured are described below:
Parameter
Begin Address
End Address
Click the Apply button to add a new entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the Delete button to remove the specific entry.

DHCP Server Pool Settings

The following windows will allow users to create and then set the parameters for the DHCP Pool of the Switch's
DHCP server.
To view the following window, click Network Application > DHCP > DHCP Server > DHCP Server Pool Settings,
as shown below:
The fields that can be configured are described below:
Parameter
Pool Name
Click the Add button to add a new entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the Edit button to configure the DHCP Server Pool Settings.
Figure 9-10 DHCP Server Exclude Address Settings window
Description
Enter the start IP address of the range.
Enter the end address of the range.
Figure 9-11 DHCP Server Pool Settings window
Description
Enter a name of the DHCP pool up to 12 alphanumeric characters.
289