Impb Port Settings - D-Link Xstack DES-3528 Series Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Trap / Log
DHCP Snooping (IPv4)
DHCP Snooping (IPv6)
ND Snooping
Recover Learning
Ports
Click the Apply button to accept the changes made for each individual section.

IMPB Port Settings

Select a port or a range of ports with the From Port and To Port fields. Enable or disable the port with the State,
Allow Zero IP and Forward DHCP Packet field, and configure the port's Max Entry.
To view this window, click Security > IP-MAC-Port Binding (IMPB) > IMPB Port Settings, as shown below:
The fields that can be configured are described below:
Figure 8-24 IMPB Global Settings window
Description
This field will enable and disable the sending of trap/log messages for IP-MAC-port
binding. When Enabled, the Switch will send a trap message to the SNMP agent
and the Switch log when an ARP packet is received that doesn't match the IP-MAC-
port binding configuration set on the Switch. The default is Disabled.
Click the radio buttons to enable or disable DHCP snooping for IPv4. The default is
Disabled.
Click the radio buttons to enable or disable DHCP snooping for IPv6.
Click the radio buttons to enable or disable ND snooping.
Enter the port numbers used to recover the learning port state. Tick the All check
box to apply all ports.
Figure 8-25 IMPB Port Settings window
230