Table of Contents
Advertisement
M-series and MX-series Devices
Configuring MSDP Peer Group
324
Configuring MSDP Peer Group (NSM Procedure) on page 324
Configuring MSDP Peers (NSM Procedure) on page 325
Configuring a Routing Table Group with MSDP (NSM Procedure) on page 327
Configuring Per-Source Active Source Limit (NSM Procedure) on page 328
Configuring MSDP Traceoptions (NSM Procedure) on page 328
Configuring MSDP Peer Group (NSM Procedure)
You can define an MSDP peer group using the Group option.
To configure an MSDP peer group in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Msdp.
4.
Add or modify settings as specified in Table 178 on page 324.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 178: Peer Group Configuration Details
Task
Define an MSDP peer group.
Apply one or more policies
to routes being exported
from the routing table into
MSDP.
Your Action
1.
Click Group next to Msdp.
2.
Click Add new entry next to Group.
3.
In the Name box, enter the name of the MSDP group.
4.
In the Comment box, enter the comment.
5.
From the Mode list, select the mesh groups.
6.
Select the Disable check box to disable MSDP.
7.
In the Local Address box, enter the IP address of the local
end of the connection.
1.
Click Export next to Group.
2.
Use the following options to select the policies to export:
Click Add after selecting a policy member from the Non
member list to add it to the Members list.
Click Remove after selecting a policy from the Members
list to remove it from the Members list.
Click Add All to add all the Non members to the Members
list.
Click Remove All to remove all the members from the
Members list.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
