Configuring MPLS Protocol (NSM Procedure)
Enabling MPLS on the Router (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
You can enable MPLS on the router using the MPLS option. See the following topics:
Enabling MPLS on the Router (NSM Procedure) on page 279
Configuring System Log Messages and SNMP Traps for LSPs (NSM
Procedure) on page 313
You can enable MPLS on the router using the MPLS option.
To enable MPLS on the router in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Mpls.
4.
Add or modify settings as specified in Table 142 on page 280.
5.
Click one:
6.
OK-Saves the changes.
Cancel-Cancels the modifications.
Chapter 20: Configuring Protocols
279