Managing M-Series And Mx-Series Devices Overview; Chapter 25 Managing M-Series And Mx-Series Devices Overview; Managing M-Series And Mx-Series Device Software Versions; Managing M-Series And Mx-Series Devices - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual
M-series and mx-series devices guide
Table of Contents
Advertisement
CHAPTER 25
Managing M-series and MX-series Devices
Overview
Managing M-series and MX-series Device Software Versions
Related Topics
Copyright © 2010, Juniper Networks, Inc.
Managing M-series and MX-series Device Software Versions on page 471
You can use Network and Security Manager (NSM) to upgrade or adjust the software on
managed M-series and MX-series devices running JUNOS Release 9.3 or later.
When a software upgrade is applied to an M-series or MX-series device with dual Routing
Engines, the upgraded software is applied to both Routing Engines. The backup is
upgraded first. The router then reboots and the backup becomes the master. Then the
former master is upgraded, as is the standard procedure for upgrading M-series and
MX-series devices with dual Routing Engines.
For more information and steps about updating the device software version, see
"Upgrading the Device Software" in the Network and Security Manager Administration
Guide.
Viewing and Reconciling Device Inventory on page 473
Comparing Device Inventory in NSM and the CLI on page 474
471
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?