Table 229: New Call Usage Policy Set Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

Copyright © 2010, Juniper Networks, Inc.

Table 229: New Call Usage Policy Set Configuration Details

Task
Configure a new call usage
policy set.
Define the new call usage
policies.
Configuring New Transaction Policy (NSM Procedure)
To configure new transaction policy in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Services > Border
3.
Signaling Gateway.
Select Gateway.
4.
Add or modify settings as specified in Table 230 on page 404.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
NOTE: For devices running JUNOS Release 9.5 and later, new transaction policy settings
will be available in the device editor only when the policy-management mode is in-device
mode. By default, new transaction policy settings can be created only in the Policy
Manager and Object Manager.
Your Action
1. Click Add new entry next to Gateway.
2. Click Sip next to gateway.
3. In the Comment box, enter the comment.
4. Click New Call Usage Policy Set next to Sip.
5. Click Add new entry next to New Call Usage Policy Set.
6. In the Name box, enter the identifier for the new call usage
policy set.
7. In the Comment box, enter the comment.
1. Click Policy Name next to new-call-usage-policy-set.
2. Click Add new entry next to Policy Name.
3. In the New policy-name window, enter the names of one or
more new call usage policies that you want to add to the set.
Syntax: To specify a list of policies, enclose the policy names
in brackets.
Chapter 23: Configuring Services
403