Configuring Authentication; Chapter 12 Configuring Authentication; Configuring Radius Authentication (Nsm Procedure); Table 52: Radius Authentication Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual
M-series and mx-series devices guide
Table of Contents
Advertisement
CHAPTER 12
Configuring Authentication
Configuring RADIUS Authentication (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Configuring Authentication Order (NSM Procedure) on page 115
Configuring User Access (NSM Procedure) on page 116
Configuring Template Accounts (NSM Procedure) on page 117
To use RADIUS authentication, you must configure at least one RADIUS server. Configuring
RADIUS authentication involves identifying the RADIUS server, specifying the secret
(password) of the RADIUS server, and setting the source address of the device's RADIUS
requests to the loopback address of the device.
To configure RADIUS authentication:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure RADIUS authentication.
Click the Configuration tab. In the configuration tree, select System > Radius Server.
3.
Add or modify Radius settings as specified in Table 52 on page 113.
4.
Click one:
5.
New-Adds a new RADIUS server.
OK-Saves the changes.
Cancel-Cancels the modifications.
Table 52: RADIUS Authentication Configuration Details
Option
Function
Name
Specifies the IP address of the RADIUS server.
Your Action
Enter the IP address of the
RADIUS server.
113
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?
Questions and answers