Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Table 116: Inet Family Configuration Details (continued)
Task
Your Action
Define one or
1.
Click Service next to Inet.
more service
2.
In the Comment box, enter the comment.
sets to be
3.
Click Input next to Service.
applied to an
4.
In the Comment box, enter the comment.
interface.
5.
In the Post Service Filter box, enter the filter to be applied to traffic after
service processing.
6.
Expand Input.
7.
Click Service Set next to Input.
8.
Click Add new entry next to Service Set.
9.
From the Name list, select the service set name.
10.
In the Comment box, enter the comment.
11.
In the Service Filter box, enter the filter name.
12.
Click Output next to Service.
13.
In the Comment box, enter the comment.
14.
Expand Output.
15.
Click Service Set next to Output.
16.
Click Add new entry next to Service Set.
17.
From the Name list, select the service set name.
18.
In the Comment box, enter the comment.
19.
In the Service Filter box, enter the filter name.
Configure an
1.
Click Unnumbered Address next to Inet.
Ethernet or
2.
In the Comment box, enter the comment.
demultiplexing
3.
In the Source box, enter the secondary IP address of the donor loopback
interface to be
interface.
unnumbered.
Configuring Protocol Family (Inet6) Information for the Logical Interface (NSM
Procedure)
To configure inet6 family information in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Interfaces.
3.
Select Interface.
4.
Add or modify settings as specified in Table 117 on page 224.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Chapter 17: Configuring Interfaces
223
Advertisement
Table of Contents
