Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual page 257

Copyright © 2010, Juniper Networks, Inc.
Table 117: Inet6 Family Configuration Details (continued)
Task
Configure the interface
address.
Configure VRRP IPV6 Group.
Your Action
1. Click Address next to Inet.
2. Click Add new entry next to Address.
3. Expand address.
4. In the Name box, enter the interface name.
5. In the Comment box, enter the comment.
6. Select the Primary check box to configure this address to be
the primary address of the protocol on the interface. If the
logical unit has more than one address, the primary address
is used by default as the source address when packets
originate from the interface and the destination does not
indicate the subnet.
7. Select the Preferred check box to configure this address to
be the preferred address on the interface. If you configure
more than one address on the same subnet, the preferred
source address is chosen by default as the source address
when you originate packets to destinations on the subnet.
1. Click Vrrp Group next to address.
2. Click Add new entry next to Vrrp Group.
3. In the Name box, enter the interface name.
4. In the Comment box, enter the comment.
5. In the Virtual Link Local Address box, enter the virtual link
local address.
6. From the priority list, select the router's priority for being
elected to be the master router in the VRRP group. A larger
value indicates a higher priority for being elected.
Range: 1 through 255
Default: 100 (for backup routers)
7. Select one of the following:
accept-data—To enable the interface to accept packets
destined for the virtual IP address.
no-accept-data—To prevent the interface from accepting
packets destined for the virtual IP address.
8. From the Authentication Type list, select the authentication
type.
9. In the Authentication Key box, enter the authentication
password.
10. Select Advertise-Interval next to vrrp-group.
11. Select one of the following:
advertise-interval—To configure the interval between
Virtual Router Redundancy Protocol (VRRP) IPv4
advertisement packets.
Range: 1 through 255 seconds
fast-interval—To configure the interval, in milliseconds,
between Virtual Router Redundancy Protocol (VRRP)
advertisement packets.
Range: 100 through 999 milliseconds
inet6-advertise-interval—To configure the interval
between Virtual Router Redundancy Protocol (VRRP)
IPv6 advertisement packets
Range: 100 to 40,950 milliseconds (ms)
Chapter 17: Configuring Interfaces
225