M-series and MX-series Devices
Configuring H248 Options Properties (NSM Procedure)
430
Table 241: Graceful Restart Configuration Details
Task
Configure graceful restart
properties.
You can configure properties for the H.248 options. See the following topics:
Configuring H248 Options (NSM Procedure) on page 430
Changing Encoding Defaults (NSM Procedure) on page 431
Configuring Service Change (NSM Procedure) on page 431
Configuring H248 Options (NSM Procedure)
You can configure options that affect virtual BGF H.248 behavior.
To configure H248 options in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 242 on page 431.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1.
Click Add new entry next to Gateway.
2.
Click Graceful Restart next to gateway.
3.
In the Comment box, enter the comment.
4.
From the Maximum Synchronization Time list, select the
maximum time allowed for the synchronization procedure
with the PIC or DPC.
Range: 0 through 300
5.
From the Maximum Synchronization Mismatches list, select
the maximum number of mismatches allowed during the
synchronization procedure with the PIC or DPC.
Range: 0 through 20000
6.
Select the No Synchronization check box to disable the
synchronization procedure with the PIC.
Copyright © 2010, Juniper Networks, Inc.
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?