Configuring Event Timestamp Notification (Nsm Procedure); Hanging Termination Detection (Nsm Procedure); Table 250: Event Timestamp Notification Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual
M-series and mx-series devices guide
Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Configuring Event Timestamp Notification (NSM Procedure)
You can enable or disable the gateway controller to access timestamp information for
media inactivity event notifications.
To configure event timestamp notification in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp .
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 250 on page 441.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Table 250: Event Timestamp Notification Configuration Details
Task
Configure event timestamp
notification.
Hanging Termination Detection (NSM Procedure)
You can enable and configure hanging termination detection using this option.
To configure hanging termination detection in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 251 on page 442.
5.
Click one:
6.
Your Action
1.
Click Add new entry next to Gateway.
2.
Click H248 Properties next to gateway.
3.
Expand H248 Properties.
4.
Click Event Timestamp Notification next to H248 Properties.
5.
In the Comment box, enter the comment.
6.
From the Request Timestamp list, select whether time stamp
information is made available to the gateway controller or is
suppressed.
Select requested to enable gateway controller access to
time stamp information for notifications.
Select suppressed to disable gateway controller access
to time stamp information for notifications.
Select autonomous which is equivalent to suppressed.
Chapter 23: Configuring Services
441
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?