M-series and MX-series Devices
Related Topics
M-series and MX-series Device Configuration Settings Supported in NSM
42
For more information about editing device configurations in NSM, including using device
templates, using configuration groups, and using configuration groups with templates,
see "Configuring Devices" in the Network and Security Manager Administration Guide.
M-series and MX-series Device Configuration Settings Supported in NSM on page 42
Configuring Device Features on page 44
Example: Configuration of Interfaces for MPLS in the CLI and NSM on page 45
You can configure JUNOS software features in NSM. Although the configuration screens
rendered in NSM look different than the JUNOS command-line interface (CLI), the
top-level configuration elements mostly correspond to commands in the CLI.
NOTE: For detailed information about configuring specific features for M-series and
MX-series devices, see the appropriate JUNOS software configuration guide.
NOTE: Because the NSM device-side configuration guides are not updated on the same
release schedule as the JUNOS releases, consult the JUNOS Software Documentation
for information about configuration settings that might occur in NSM and not in the
device-side configuration guides or vice versa.
Table 7 on page 42 provides a general guideline of the CLI hierarchy levels that are
supported in the NSM configuration tree. For the exact parameters available, double-click
the device in the Device Manager and select the Configuration tab. The configuration
tree appears in the main display area with all parameters viewable or configurable from
NSM.
Table 7: The JUNOS Configuration Hierarchy and the NSM Configuration
Tree
Hierarchy Level
edit access
edit accounting-options
edit applications
edit bridge domains
edit chassis
edit class-of-service
Available in the NSM
Configuration Tree
Yes
Yes
Yes
Yes
Yes
Yes
Copyright © 2010, Juniper Networks, Inc.
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?