Configuring Differentiated Services (Nsm Procedure); Table 249: Diffserv Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

M-series and MX-series Devices
440
Table 248: Base Root Package Configuration Details (continued)
Task
Set default, maximum, and
minimum values for the
normal MGC execution time
property of the base root
package.

Configuring Differentiated Services (NSM Procedure)

You can configure default values for properties in the Differentiated Services (DiffServ)
package using the Diffserv option.
To configure DiffServ in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 249 on page 440.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.

Table 249: Diffserv Configuration Details

Task
Configure default values for
properties in the
Differentiated Services
(DiffServ) package.
Your Action
1. Click Normal Mgc Execution Time next to Base Root.
2. In the Comment box, enter the comment.
3. From the Default list, select the default interval within which
the virtual BGF waits for a response to transactions from the
gateway controller.
Range: 500 through 29,000 milliseconds.
Your Action
1. Click Add new entry next to Gateway.
2. Click H248 Properties next to gateway.
3. Expand H248 Properties.
4. Click Diffserv next to H248 Properties.
5. In the Comment box, enter the comment.
6. Click Dscp next to Diffserv.
7. In the Comment box, enter the comment.
8. From the Default list, select the default values for
Differentiated Services Code Point (DSCP) marking that the
virtual BGF uses for outgoing traffic when the DSCP value is
not already defined by the gateway controller.
Copyright © 2010, Juniper Networks, Inc.