Table of Contents
Advertisement
M-series and MX-series Devices
Table 68: Assigning Forwarding Classes to Output Queues (continued)
Task
Configure an assured forwarding
class and scheduler.
Apply the scheduler map to an
interface.
Related Topics
Configuring CoS Restricted Queues (NSM Procedure)
142
Action
1.
Select Forwarding Class and click Add new entry.
2.
In the Name box, type the name of the previously configured assured forwarding
class—for example, af-class.
3.
Select the previously configured assured forwarding scheduler—for example,
af-scheduler.
4.
Click
OK
.
1.
Select Interfaces > Interface and click Add new entry.
2.
In the Interface name box, type the name of the interface—for example, ge-0/0/0.
3.
Select Unit and click Add new entry.
4.
In the Unit name box, select the logical interface unit number—for example, 0.
5.
In the Scheduler map box, type the name of the previously configured scheduler
map—for example, diffserv-cos-map.
6.
Click OK.
Configuring CoS Classifiers (NSM Procedure) on page 122
Configuring CoS Code Point Aliases (NSM Procedure) on page 124
Configuring CoS Drop Profile (NSM Procedure) on page 125
Configuring CoS Forwarding Classes (NSM Procedure) on page 127
Configuring CoS Interfaces (NSM Procedure) on page 132
Configuring CoS Rewrite Rules (NSM Procedure)
Configuring CoS Schedulers (NSM Procedure) on page 139
You can map the forwarding classes to the restricted queues for M320 and T Series
routers. You can map up to eight forwarding classes to restricted queues.
To configure Class of Service restricted queues in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Class of Service.
3.
Select Restricted Queue.
4.
Add or modify settings as specified in Table 69 on page 143.
5.
Click one:
6.
OK—Saves the changes.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?