Table 206: Flow Route Fields - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

Table 206: Flow Route Fields

Option
Comment
Route
Name
Comment
Match
Then
Validation
Comment
Copyright © 2010, Juniper Networks, Inc.
Function
Specifies the comment for the flow
route.
Specifies the name of the flow route.
Specifies the comment for the flow
route.
Specifies the conditions that the packet
must match for the packet to be
included in flow route. Match conditions
are:
Destination Port
DSCP
Fragment
Icmp Code
Icmp Type
Packet Length
Port
Protocol
Source Port
Tcp Flag
Enables you to specify the action to take
if the packet matches the conditions you
have configured in the flow route.
Specifies a comment for the validation
procedure. Flow routes are installed into
the flow routing table only if they have
been validated using the validation
procedure.
Chapter 21: Configuring Routing Options
Your Action
Enter a comment.
1. Expand the tree and select
Flow
.
Route
2. Click the New button or select a
flow route and click the Edit button.
3. Enter the flow route name.
1. Expand the tree and select
Flow
.
Route
2. Click the New button or select a
flow route and click the Edit button.
3. Enter the comment for the flow
route.
1. Expand the Route tree and select
Match .
2. Enter a comment for
Comment
destination address for
Destination
and a source address for
3. Configure the match conditions.
1. Expand the tree and select
Route
.
Then
2. Configure the then conditions for
the packet.
1. Expand the tree and select
Flow
.
Validation
2. Enter the comment for the
validation procedure.
, a
,
.
Source
367