Table 72: Translation Table Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

M-series and MX-series Devices
146
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Class of Service.
3.
Select Translation Table.
4.
Add or modify settings as specified in Table 72 on page 146.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 72: Translation Table Configuration Details

Task
Translate incoming IPv4 DSCP values to new
values.
Your Action
1. Click To Dscp From Dscp next to
Translation Table.
2. Click Add new entry next to To Dscp From
Dscp.
3. In the Name box, enter the IPv4 DSCP
values.
4. In the Comment box, enter the comment.
5. Click To Code Point next to
to-dscp-from-dscp.
6. Click Add new entry next to
to-dscp-from-dscp.
7. From the Name list, select the DSCP.
8. In the Comment box, enter the comment.
9. Click From Code Points next to
to-code-point and perform the following:
Add—Adds the selected code points
from the Non member list to the
Members list.
Remove—Removes the selected code
points from the Members list.
Add All—Adds all the code points from
the Non-members list to the Members
list.
Remove All—Removes all the code
points from the Members list.
Copyright © 2010, Juniper Networks, Inc.