Configuring Per-Source Active Source Limit (Nsm Procedure); Configuring Msdp Traceoptions (Nsm Procedure); Table 181: Active Source Limit Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

M-series and MX-series Devices
328

Configuring Per-Source Active Source Limit (NSM Procedure)

You can configure an active source limit for an address range as well as for a specific
peer. A per-source active source limit uses an IP prefix and prefix length instead of a
specific address. You can configure more than one per-source active source limit. The
longest match determines the limit.
To configure an active source limit for an address range as well as for a specific peer in
NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Msdp.
4.
Add or modify settings as specified in Table 181 on page 328.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 181: Active Source Limit Configuration Details

Task
Configure an active source
limit for an address range as
well as for a specific peer.
Configure active source limit.

Configuring MSDP Traceoptions (NSM Procedure)

You can configure the MSDP traceoption using the Traceoption option.
To configure traceoptions in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Your Action
1. Click Source next to Msdp.
2. Click Add new entry next to Source.
3. In the Name box, enter the IP address.
4. In the Comment box, enter the comment.
1. Click Active Source Limit next to source.
2. In the Comment box, enter the comment.
3. From the Maximum list, select the maximum number of
active source messages.
Range: 1 through 1,000,000
Default: 25,000
4. From the Threshold list, select the RED threshold for active
source messages.
Range: 1 through 1,000,000
Default: 24,000
Copyright © 2010, Juniper Networks, Inc.