Configuring Traceoptions (Nsm Procedure); Table 232: Timers Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

Copyright © 2010, Juniper Networks, Inc.
Select Gateway.
4.
Add or modify settings as specified in Table 232 on page 407.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 232: Timers Configuration Details

Task
Configure timers used to
issue SIP timeouts.

Configuring Traceoptions (NSM Procedure)

You can configure border signaling gateway tracing operations using the Traceoptions
option:
To configure traceoptions in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Services > Border
3.
Signaling Gateway.
Select Gateway.
4.
Add or modify settings as specified in Table 233 on page 408.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Click Add new entry next to Gateway.
2. Click Sip next to gateway.
3. In the Comment box, enter the comment.
4. Click Timers next to Sip.
5. In the Comment box, enter the comment.
6. From the Inactive Call list, select the maximum time for
signaling inactivity.
Range: 300 through 86400
7. From the Timer C list, select the duration of the timeout
period.
Range: 180 through 300
Chapter 23: Configuring Services
407