Table of Contents
Advertisement
M-series and MX-series Devices
274
Table 140: LDP Configuration Details (continued)
Task
Configure LDP protocol-level
trace options.
Configure LDP traffic
statistics.
Your Action
1.
Click Traceoptions next to Ldp.
2.
In the Comment box, enter the comment for the traceoptions.
3.
Click File next to Traceoptions.
4.
In the Comment box, enter the comment for the file.
5.
In the Filename box, enter the name of the file to receive the
output of the tracing operation.
6.
In the Size box, enter the maximum size of each trace file, in
kilobytes (KB), megabytes (MB), or gigabytes (GB).
7.
From the Files list, select the maximum number of trace files.
Range: 2 through 1000
8.
Select one of the following:
world-readable—To enable unrestricted file access.
no-world-readable—To restrict file access to owner. This
is the default setting.
1.
Click Traffic Statistics next to Ldp.
2.
In the Comment box, enter the comment.
3.
From the Interval list, select the interval at which the statistics
are polled and written to the file.
Range: 60 through 65535
4.
Select No Penultimate Hop check box to disable penultimate
hop statistics collection.
5.
Click File next to Traffic Statistics.
6.
In the Comment box, enter the comment for the file.
7.
In the Filename box, enter the name of the file to receive the
output of the tracing operation.
8.
In the Size box, enter the maximum size of each trace file, in
kilobytes (KB), megabytes (MB), or gigabytes (GB).
9.
From the Files list, select the maximum number of trace files.
Range: 2 through 1000
10.
Select one of the following:
world-readable—To enable unrestricted file access.
no-world-readable—To restrict file access to owner. This
is the default setting.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?