Table 67: Configuring Schedulers - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

M-series and MX-series Devices

Table 67: Configuring Schedulers

Task
Specify the buffer size.
Configure drop profile
map.
Specify the transmit rate.
Related Topics
140
Action
1. Click the Add New icon.
2. Expand Buffer Size.
3. Select Percent.
4. Under Percent, select the appropriate option:
To specify no buffer size, select None.
To specify buffer size as a percentage of the total buffer, select percent and type an integer
from 1 through 100.
To specify buffer size as the remaining available buffer, select remainder.
5. Click OK.
1. Click the Add New icon.
2. Select drop-profile-map.
3. In the Loss Priority box, select the required loss priority—for example, high.
4. In the Protocol box, select the type of protocol—for example, any.
5. In the Drop Profile box, select the previously configured drop profile.
6. Click .
OK
1. Click the Add New icon.
2. Expand Transmit Rate.
3. Select Rate.
4. Under Rate, select the appropriate option:
To not specify transmit rate, select None.
To enforce a specific transmission rate, select rate and type the transmission rate that you
want to enforce.
To specify a percentage of transmission capacity, select percent and type an integer from
1 through 100.
To specify the remaining transmission capacity, select remainder.
5. Click OK.
Configuring CoS Classifiers (NSM Procedure) on page 122
Configuring CoS Code Point Aliases (NSM Procedure) on page 124
Configuring CoS Drop Profile (NSM Procedure) on page 125
Configuring CoS Forwarding Classes (NSM Procedure) on page 127
Configuring CoS Interfaces (NSM Procedure) on page 132
Configuring CoS Rewrite Rules (NSM Procedure)
Configuring CoS and Applying Scheduler Maps (NSM Procedure) on page 141
Copyright © 2010, Juniper Networks, Inc.